AIR CONDITIONER DETAIL INSTALL |SPLIT DUCTLESS AC HEATING INVERTER,MINI PUMP SYSTEM SETUP,DIY HOW TO Iga świątek [C98R5B2CcMo]

MINI SPLIT AC: |

AC RUBBER MOUNTS: |

CROWFOOT SET: |

PIPE INSULATION TUBING: |

INSULATING FOAM SEALANT: |

AC LINE COVER KIT: |

vacuum hand pump: |

spirit level: |

folding ruler: |

BoschHammer: |

sds hammer drill set: |

wet & dry vacuum cleaner: |

raw plugs: |

screw assortment: |

cordless impact driver: |

long masonry drill: tiafoe |

concrete hole saw: |

insulated screwdriver: |

torque wrench: |

3/8 wrench adapter: |

adjustable wrench: |

duct tape: |

ac wall mount: |

pvc pipe elbow: |

pvc pipe: |

wrench socket set: |

wall cord cover: |

vacuum hand pump: |

gopro camera: |

gopro head strap: |

gopro pole mount: |

gopro tripod adapter: |

tripod: |

my drone: |

The links above are affiliate links that belong to Amazon or Ebay partner programs. If you buy something through these links, I will receive a commission, of course without you having to pay anything more. Thanks for your support!

For contact options and links check my channel info,

Thank you for your interest in my videos!

transkript: Hello here is Carl the landscape guy. In my new office Im installing a split air conditioner system, that will be used for both heating and air conditioning. The model I chose is a 9,000 BTU 2.6 kw precharged inverter kit. Among other things, the manufacturer advertises that this system saves energy and is very quiet. It has an antibacterial coating on the fins, works with a new, environmentally friendly refrigerant and can be controlled via WLAN with a smartphone app. This system comes with the coolant prefilled unit, 9 feet of refrigerant piping, and small parts such as a feedthrough tube, insolation tape, sealant and rubber mounts. There is also the outer wall bracket, which I will show you later, when it comes to the assembly of the outside unit. Then here we have the indoor unit, which is very light. It comes with a cable that will connect both units. It also includes the manual, the remote control and a wall holder for it. Both devices seemed to have been well-packed and arrived undamaged. This is the back of the wall mount. The indoor unit will go on this brick and concrete wall. I measure the distance between the holes of the wall bracket from the outer edge of the unit. Horizontally, the plate is slightly adjustable. A minimum distance of half a foot from the ceiling must be kept so that the air can flow properly. I draw the height of the upper holes with the pechino express help of a level. The wall bracket can be easily detached from the plastic unit. It clips on at the bottom. I use the bracket to mark all holes exactly. I use a 5 mm masonry drill with a Bosch Hammer to make the holes. When drilling indoors I use the Krcher wet & dry vacuum cleaner to catch most of the dust. In case you are interested, I will link all tools below in the video description. By the way, the rawl plugs and screws were not included. Now I will prepare to drill the 65mm hole in the wall. First I mark the position of the hole. You will find the distances for the hole in the installation manual, they are different for each unit. I use a long masonry drill to pre-drill the shank hole. I make sure that the hole is angled on a downward slope. When dortmund vs eintracht frankfurt the guiding hole is all set, I set up the 65mm concrete shank drill bit and start making the hole little by little. Every few inches I empty out the drill. I drill from the inside out as far as I can get....

#aircondition #split #minisplit